remont-555.net

Length furnace furnace heater must be good. Oposlya the temperature of the walls of the furnace will reach its maximum value, establishes a balance between the heat generated in the oven and bring to the surrounding air. Next burner stove repeated acts to be feasible. Stove persistent acts have to drown unless you want the highest temperature of the stones to produce steam.
Fundamental importance is the size of the fuel line fuel consumption. The larger this size, the greater should be the fuel consumption, so that the combustion process was intense and the share of losses from the output gases was small.

Stoves, heaters installed in the steam bath units steam bath for heating and steam room, where the obligation to keep the temperature about 40-100 ° C. Furnace heater consists of a firebox for firewood and a closed chamber where the body of the firebox laid cobblestones and cast iron ingots with a layer of 20-22 cm, extreme add to the cobbles, so speeding up the heating furnace stove (cast iron is heated rather than a boulder). In the vault there are cracks, flue gases passing through them, penetrate the thick stone and ingots, more flue gases fall into two side-side drop-channel, and hence are removed in the chimney.
Cost-effective combustion of fuel. Cost-effective introduction of fuel may be, in full burn. Rational conditions are created during combustion of solid fuel on grate grids. With all this air comes from below to fuel the entire area of the firebox through a grid of ash. This air, called the primary, spent mainly for the oxidation of combustible components of fuel to form carbon dioxide (carbon dioxide) and water vapor. When the temperature of the fuel, especially from the wood stand out combustible gases, which burns in the gas space above the fuel. Touching the carbon residue of fuel at the highest temperature, carbon dioxide is reduced to form and fuel gas – carbon monoxide (carbon monoxide).